Control System 42Service Manual – SC6500
™
7. Press the scrub off switch to save the setting and display the key switch icon.
8. Turn the key switch off. The new setting will be saved until changed again.
Indicator LED Intensity Selection Option
Note that the factory default setting for the indicator LED intensity is normal.
To change the intensity of the LEDs in the control panel indicators.
1. Turn the key switch off.
2. Press and hold the vacuum/wand and scrub speed switches.
3. While holding both switches, turn the key switch on.
4. Continue to hold both switches until the vacuum/wand and scrub speed indicators turn on. The display
will now show a light bulb icon in the upper left corner indicating the LED light intensity selection.
5. Release both switches. The scrub speed and scrub off indicators will light and the vacuum/wand
indicator will blink.
6. Press the vacuum/wand switch to select between the normal intensity or extra bright intensity levels.
7. Press the scrub off switch to save the setting and display the key switch icon.
8. Turn the key switch off. The new setting will be saved until changed again.
Detergent and Solution Pump Purge
The EcoFlex
™
detergent system has two purge (ush) programs to ensure that the detergent delivery hoses
and related components are kept open and clean. A general operational description in how the system
functions is found in the Solution System section. To activate the maintenance purge functions:
Method 1
1. Turn the key switch off.
2. Press and hold both the detergent and solution switches.
3. While holding the switches, turn the key switch on. The display will show the purge icon, the detergent
and solution pumps will run for approximately 20 seconds, then the pumps will shut off.
4. When the purge cycle is complete, turn the key switch off.
Method 2 (as described in the Instructions for Use)
1. Turn the key switch on.
2. Press and hold both the detergent and solution switches for three seconds. The detergent and solution
pumps will run for approximately 10 seconds.
3. When the purge cycle is complete, turn the key switch off.
To Next Page
Loading...
Need help?
General
