Section 10 Transferring Data
NS-Designer Operation Manual
Section 10 Transferring Data
This section explains how to transfer screen data that has been created or edited to and from the PT, and how to
retrieve registered data from the PT.
10-1 Transferring Data to the PT....................................................................................................................................... 10-1
10-2 Transferring Data to and from a Memory Card ....................................................................................................... 10-29
10-3 Data Transfer Using SPMA..................................................................................................................................... 10-33
Note: Do not perform the following operations while downloading or uploading project data or the system pro-
gram. The data may be damaged.
Turn OFF the power to the PT.
Press the PT reset switch.
If project data or the system program is damaged by turning OFF the power when writing files, it may not
be possible to replace the system program using a normal data transfer. If project data is damaged, format
the screen data areas using the system menu of the PT. Refer to 6-2-1 Screen Data Area Format in the NS
Series Setup Manual for details on formatting screen data areas. Refer to 3-6-3 Transferring Data with
Memory Cards – Errors in the NS Series Setup Manual to replace the System Program.
Do not download a system program earlier than version 6.2 to an NS5-V2 PT. Refer to 3-6-3Transferring
Data with Memory Cards – Errors in the NS Series Setup Manual for information on updating and recover-
ing the system program.
To Next Page
Loading...
Need help?
General
