5-8
5
User Parameter Tables
îš‹ Setup Settings: A
îš„ Initialize Mode: A1
Param-
eter
Num-
ber
Name
Description
Setting
Range
Factory
Setting
Change
during
Opera-
tion
Control Methods
MEMO-
BUS
Register
Page
V/f
V/f
with
PG
Open
Loop
Vector
Closed
Loop
Vector
Display
A1-00
Language
selection for
Digital
Operator
display
Used to select the language
displayed on the Digital Oper-
ator (JVOP-160 only).
0: English
1: Japanese
2: German
3: French
4: Italian
5: Spanish
6: Portuguese
This parameter is not changed
by the initialize operation.
0 to 6 0 Yes A A A A 100H –
Select
Language
A1-01
Parameter
access level
Used to set the parameter
access level (set/read.)
0: Monitoring only
(Monitoring drive mode
and setting A1-01 and A1-
04.)
1: Used to select user param-
eters (Only parameters set
in A2-01 to A2-32 can be
read and set.)
2: Advanced
(Parameters can be read
and set in both, quick
programming mode (Q)
and advanced
programming mode (A).)
0 to 2 2 Yes A A A A 101H 6-144
Access
Level
A1-02
Control
method
selection
Used to select the control
method for the Inverter
0: V/f control
1: V/f with PG feedback
2: Open loop vector
3: Closed Loop Vector
This parameter is not changed
by the initialize operation.
0 to 3 2 No Q Q Q Q 102H
4-5
4-7
4-14
Control
Method
A1-03
Initialize
Used to initialize the parame-
ters using the specified
method.
0: No initializing
1110: Initializes using the
user parameters
2220: Initializes using a
two-wire sequence.
(Initializes to the
factory setting.)
3330: Initializes using a
three-wire sequence.
0 to
3330
0NoAAAA103H–
Init Parame-
ters
To Next Page
Loading...
Need help?
General