Omron VARISPEED F7 User Manual

3-5
3
 Switching Modes
The mode selection display will appear when the MENU key is pressed. Press the MENU key from the mode
selection display to switch through the modes in sequence.
Press the DATA/ENTER key to enter a mode and to switch from a monitor display to the setting display.
Fig 3.3 Mode Transitions
IMPORTANT
To run the inverter after viewing/changing parameters press the MENU key and the DATA/ENTER
key in sequence to enter the Drive mode. A Run command is not accepted as long as the drive is in
any other mode.
Frequency Ref
-DRIVE-
U1-02=50.00Hz
U1-03=10.05A
** Main Menu **
-DRIVE-
Operation
** Main Menu **
-QUICK-
Quick Setting
** Main Menu **
-ADV-
Programming
** Main Menu **
-VERIFY-
Modified Consts
** Main Menu **
-A.TUNE-
Auto-Tuning
Rdy
U1- 01=50.00Hz
Monitor
-DRIVE-
U1-02=50.00Hz
U1-03=10.05A
Rdy
U1 - 01=50.00Hz
Control Method
-QUICK-
A1-02=2
Initialization
-ADV-
A1 - 00=1
Select Language
None Modified
-VERIFY-
Frequency Ref
-DRIVE-
U1-02=50.00Hz
U1-03=10.05A
U1- 01=50.00Hz
Frequency Ref
-DRIVE-
Rdy
U1- 01=
0
50.00Hz
Control Method
-QUICK-
A1-02= 2
Open Loop Vector
Select Language
-ADV-
A1- 00 =0
*1*
English
-ADV-
Select Language
English
The constant number will be displayed if a
constant has been changed. Press the
DATA/ENTER key to enable the change.
Monitor Display Setting Display
Mode Selection
Display
Display at Startup
Open Loop Vector
Tuning Mode Sel
-A.TUNE-
Standard Tuning
"0"
Tuning Mode Sel
-A.TUNE-
Standard Tuning
"0"
*2*
Rdy
A1- 00= 0
*1*
T1- 01=0 1
*0*
T1- 01= 0
*0*
*2*
MENU
MENU
MENU
MENU
MENU
RESET
RESET
ESC ESC ESC
ESC ESC
ESC ESC ESC
ESC
ESC ESC
(0.00 ~ 50.00)
" 00.00Hz "

Omron VARISPEED F7 Specifications

General

Brand	Omron
Model	VARISPEED F7
Category	Inverter
Language	English