PIAGGIO Carnaby 125 - Brake Pump Service

Front brake pump
Removal
- Remove the front handlebar cover.
- Remove the rear handlebar cover.
- Drain the braking system.
- Disconnect the brake fluid pipe from the pump,
paying attention to a possible escape of remaining
brake fluid.
- Remove the front brake stop button from the lev-
er.
- Loosen the two fixing screws of the stand and
remove together with the rear view mirror.
- Remove the front brake pump together with the
lever.
See also
Rear handlebar cover
Front
Overhaul
1) Remove the brake lever by loosening the fixing screw;
open the cover (2) and take out the diaphragm (3);
2) Remove the cap and unscrew the internal parts in the specified order;
3) Check that:
- The body of the pump shows no signs of internal damage or corrosion;
- The piston shows no sign of damage or abnormal wear;
- The piston return spring is in good condition.
Refitting
Reinstall the individual parts in the reverse order to the removal, paying attention to the correct posi-
tioning of the rubber parts in order to ensure leak tightness.
1. Tank cover screw
2. Tank cover
3. Diaphragm
4. Bellows
Carnaby 125 - 200 Braking system
BRAK SYS - 229