31. Pulsante clacson
32. Termointerruttore
33. Elettroventola
34. Commutatore lampeggiatori
35. Pompa elettrica carburante
36. Dispositivo comando pompa elettrica
Checks and inspections
Ignition circuit
No spark plug
Once the lack of power to the spark plug has been
detected and the LED indicates it can be ignited,
follow this procedure:
- Pick-Up check.
Disconnect the control unit connector and check
the resistance value between terminal No. 6
(Green) and terminal No. 8 (Black). Check the
Pick-Up and its power line:
Electric characteristic
Pick-up resistance value
Pick-up resistance value: 105 ÷ 124 Ohm
If a break in the circuit is found, check again the flywheel and the engine ground connectors (see engine
manual). If non-conforming values are measured, replace the Pick-Up; otherwise, repair the cable har-
ness.
In case conforming values are measured, try replacing the control unit (without programming) and make
sure the failure has been solved by checking sparks are produced in the spark plug; only then program
the control unit.
Electrical system Carnaby 125 - 200
ELE SYS - 82
To Next Page
Loading...
Need help?
General