8.10
9924874 R02 - 2014 RZR XP / XP 4 1000 Service Manual
© Copyright 2013 Polaris Industries Inc.
13. Remove the spacer or support between the vehicle
frame and engine.
14. Install and properly route the gear position switch
connector (Item 5), speed sensor connector (Item 6),
crankshaft position sensor connector (Item 7), shift
bracket and shift bracket bolts (Item 8), shift cable
clevis pin and washer (Item 9) onto the transmission.
15. Torque the two shift cable bracket bolts to
specification.
Shift Cable Bracket Bolts:
17 ft-lb (23 Nm)
16. Install three wire ties to retain wire harness to
transmission and mounts.
17. Install and properly route the vent hose.
18. Lubricate the transmission splines and mid propshaft
joint splines with Polaris All Purpose Grease. Install
the propshaft onto the transmission output shaft (see
Chapter 7).
19. Install inner clutch cover, outlet duct, drive clutch,
driven clutch, belt and outer clutch cover (see
Chapter 6).
20. Install new spring ring (Item 10) on rear drive shafts.
Apply an anti-seize compound to the splines (Item
11).
21. Remove lower shock mounting bolt and swing the
rear trailing arm out and up. Align the splines of the
drive shaft with the transmission splines. Push
inward on the trailing arm assembly until the rear
drive shafts lock into the transmission splines.
22. Install the rear shocks onto the trailing arms and
install the lower mounting bolts with new retaining
nuts. Torque to specification.
TRANSMISSION
To Next Page
Loading...
Need help?
General
