Controller Options
SM 2-101 D037/D038/D040/D041
Installaion
12. Go into the User Tools mode, and select System Settings> Administrator Tools> Auto
Erase Memory Setting> On.
13. Exit the User Tools
mode.
14. Check the display
and make sure that
the overwrite erase
icon [A] shows.
15. Check the overwrite erase icon.
 The icon [B]: This icon is lit when there is temporary data to be overwritten, and
blinks during overwriting.
 The icon [C]: This icon is lit when there is no temporary data to be overwritten.
2.22.9 HDD ENCRYPTION UNIT (D038/D041 ONLY)
Before You Begin the Procedure
1. Make sure that the following settings are not at the factory default settings:
 Supervisor login password
 Administrator login name
 Administrator login password
 These settings must be set up by the customer before the HDD Encryption
unit can be installed.
2. Confirm that "Admin. Authentication" is on:
[User Tools] > "System Settings"> "Administrator Tools"> "Administrator Authentication
Management"> "Admin. Authentication"> "On"
If this setting is "Off", tell the customer that this setting must be "On" before you can do
the installation procedure.
3. Confirm that "Administrator Tools" is selected and enabled:
[User Tools]> "System Settings"> "Administrator Tools"> "Administrator Authentication
Management"> "Available Settings"
 "Available Settings" is not displayed until Step 2 is done.
If this setting is not selected, tell the customer that this setting must be selected before
you can do the installation procedure.
Rev. 02/2009
To Next Page
Loading...
Need help?
General
