Ricoh D296 User Manual

3.System Maintenance
49
Software Update
Updating the Smart Operation Panel
There are four methods to update the Smart Operation Panel. The method is different depending on what you want
to update.
1. Installation/update from an SD card
2. Package update
3. Installation/update from the eDC Server
4. Installation/update from Application Site
Update method Features Control
panel
firmware
Applications
Installation/update
from an SD card
Update using an SD card.
• This is the only method to install an
older version of currently installed
software.
• Enter the recovery mode to update the
control panel firmware.
• Use the installation screen in the
control panel’s service mode to
update applications.
• You can install or update multiple
applications at once.
• You can also uninstall an application.
Yes Yes
Package update Uses the Package update function of the GW+ controller
to update the software.
• The software is updated in the
following order: controller firmware,
applications, and then the control
panel firmware.
• The procedure for updating the
control panel firmware is the same as
when updating from an SD card using
Recovery mode.
Yes Yes
Installation/update
from the eDC Server
Downloads applications from the eDC Server for
installation or update.
This method is mainly for paid applications. A product
key is required when an application is installed for the
No Yes

Ricoh D296 Specifications

General

Brand	Ricoh
Model	D296
Category	Printer
Language	English