2.Replacement and Adjustment
18
2. Replacement and Adjustment
FCU
When you replace the FCU board, transfer the SRAM data from the old FCU board to the new FCU board. Do the
following procedure to back up the SRAM data.
The following data can be transferred: TTI, RTI, CSI, Fax bit switch settings, RAM address settings, NCU
parameter settings.
SRAM Data Transfer Procedure
Unplug the power cord before starting the following procedure.
1. Remove the rear cover [A].
2. Remove the paper feed tray, and then open the front cover.
To Next Page
Loading...
Need help?
General
