Ricoh D296 User Manual

PCDU, Toner Supply
252
4. Remove the shaft [A], bearing [B], and gear [C]. ( × 1 each)
5. Remove the toner supply motor [A]. ( × 2 each)
Toner Transport Section
Before Replacing the Toner Transport Section
Before replacing the toner transport section (the toner sub-hopper), reset the PM counter and execute the forced
toner supply.
1. Turn the power ON.
2. Enter the SP mode.
3. Set the following SPs (Manual New Unit Set) to “1” depending upon the color of the replaced unit to reset
the PM counter.
• SP3-701-220 (Manual New Unit Set: Toner Sub Hopper:Bk)
• SP3-701-221 (Manual New Unit Set: Toner Sub Hopper:C)
• SP3-701-222 (Manual New Unit Set: Toner Sub Hopper:M)
• SP3-701-223 (Manual New Unit Set: Toner Sub Hopper:Y)
4. Set the following SPs (Toner supply flag) to “1” depending upon the color of the replaced unit.
• SP3-510-031 (Image Quality Adj.: Exec Flag Init Toner Replenishment: Bk)
• SP3-510-032 (Image Quality Adj.: Exec Flag Init Toner Replenishment: C)
• SP3-510-033 (Image Quality Adj.: Exec Flag Init Toner Replenishment: M)
• SP3-510-034 (Image Quality Adj.: Exec Flag Init Toner Replenishment: Y)
5. Exit from the SP mode.
6. Turn the power OFF.

Ricoh D296 Specifications

General

Brand	Ricoh
Model	D296
Category	Printer
Language	English