The following message appears:
Press # to
clean heads
2. Press the [#Enter] key.
Head cleaning starts.
Head-flushing
Follow the procedure below to perform a thorough print head cleaning. Because head flushing
consumes more ink than head cleaning, do it only if the print head cannot be cleaned properly by head
cleaning.
When the print cartridge is empty, replace it instead of performing a print head cleaning. After a print
cartridge is replaced, a print head cleaning will be automatically performed.
• Do not turn the machine off during print head cleaning. If the machine is turned off during print
head cleaning, start again from the beginning.
1. Press the [ /Menu] key.
2. Press the [ ] or [ /Menu] key to display [Maintenance], and then press the [#Enter] key.
Menu:
Maintenance
3. Press the [ ] or [ /Menu] key to display [Head-flushing], and then press the [#Enter]
key.
Maintenance:
Head-flushing
4. Machine Setup Menus
134
To Next Page
Loading...
Need help?
General