6. Connect the power cord, USB cable, or Ethernet cable.
• After attaching an option, check that the printer driver has recognized it. See page 109
"Specifying Settings on [Accessories] Tab", page 186 "Displaying the Machine Status on a
Macintosh".
• After attaching the multi bypass tray, you must register where to start printing on paper loaded in
the multi bypass tray. See page 140 "Registration".
• The coin screw on the underside of the multi bypass tray is used when setting the side fence.
Detaching the multi bypass tray
1. Press and hold down the [Power] key until it turns off, and then unplug the power cord.
2. Disconnect the USB cable or Ethernet cable.
3. Remove any paper in the bypass tray.
4. If the bypass tray extension is pulled out, push it back in.
5. Pressing the tabs on each side of the multi bypass tray, detach the unit.
To Next Page
Loading...
Need help?
General