If you are using a distance gauge, travel as close to the fixed point as
possible, measure the gap with the distance gauge and enter the value
in "DZ".
The distance gauge is approached with the spindle stationary.
8. Press the "Set length" softkey.
The tool length is calculated automatically and entered in the tool list.
4.5.5 Measuring radius or diameter
Procedure
1. Insert the tool you want to measure in the spindle.
Select "JOG" mode in the "Machine" operating area.
2. Press the "Meas. tool" softkey.
3. Press the "Radius manual" or "Diam. manual" softkey.
4. Select the cutting edge number D and the the number of the replacement
tool ST.
5. Approach the workpiece in the X or Y direction and perform scratching
with the spindle rotating in the opposite direction.
6. Specify the setpoint position X0 or Y0 of the workpiece edge.
7. Press the "Set radius" or "Set diam." softkey.
The tool radius or diameter is calculated automatically and entered in the
tool list.
Note
Tool measurement is only possible with an active tool.
Setting up the machine
4.5 Measure tool
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0 103
To Next Page
Loading...
Need help?
General
