All the operations supported by the PLC type are available for the editing. Subprograms and
interrupt programs can be added and deleted.
Note
Saving changes
If you make changes in the program, you must save the project before you change from the
PLC area to another operating area. You can transfer the project to the PLC using the "Load
to CPU" softkey. If this is not done, all of the changes will be lost and must be re-entered.
Please note the corresponding program information:
Editing functions
● Edit block
– Create connecting lines, contacts, coils, and boxes
– Change operands
– Delete operations
● Network
– Create
Create and then edit a new network
– Edit
Subsequently edit networks
– Delete
Delete networks
References
For information, please refer to the Basic Functions Function Manual, Chapter P4: PLC for
SINUMERIK 828D
23.5.8.2 Editing a program block
You can edit program blocks.
Requirement
Before you can edit program blocks, the program status must have stopped.
If the status is active, you will receive a message that the program status must have stopped.
1. To stop the program status automatically, press the "OK" softkey.
- OR -
To stop the program status, press the "Program stat." softkey again.
Edit PLC user program (828D only)
23.5 View of the program blocks
Milling
916 Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
To Next Page
Loading...
Need help?
General
