Requirements
● The required program is opened in the mold making view.
● The "Graphic" softkey is active.
Procedure
1. Press the ">>" and "Select point" softkeys.
Cross-hairs for selecting a point are shown in the diagram.
2. Using the cursor keys, move the cross-hairs to the desired position in the
graphic.
3. Press the "Select NC block" softkey.
The cursor jumps to the associated program block in the editor.
6.15.5 Searching for program blocks
Using the "Search" function, you can go specifically to program blocks where you can edit
programs. You can find and replace text in one step.
Precondition
● The required program is opened in the mold making view.
● The "NC blocks" softkey is active.
Procedure
1. Press the "Search" softkey.
A new vertical softkey bar appears.
See also
Searching in programs (Page 214)
Replacing program text (Page 216)
Machining the workpiece
6.15 Mold making view
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0 261
To Next Page
Loading...
Need help?
General
