Hidden parameters
The following parameters are hidden. They are pre-assigned fixed values or values that can
be adjusted using setting data.
Parameter Description Value Can be set in SD
PL (only for G code) Machining plane Defined in MD
52005
SC (only for G
code)
Safety clearance 1 mm x
Predrilling
ZA Predrilling depth
FA Reduced predrilling feedrate
Through drilling
ZD Depth for reduced feedrate
FD Reduced through drilling feedrate
Machine manufacturer
Please refer to the machine manufacturer's specifications.
10.1.4 Reaming (CYCLE85)
Function
With the "Reaming" cycle, the tool is inserted in the workpiece with the programmed spindle
speed and the feedrate programmed at F.
If Z1 has been reached and the dwell time expired, the reamer is retracted at the programmed
retraction feedrate to the retraction plane.
Approach/retraction
1. The tool moves with G0 to safety clearance of the reference point.
2. The tool is inserted into the workpiece with the programmed feedrate F until it reaches the
final depth Z1.
3. Dwell time DT at final drilling depth.
4. Retraction to retraction plane with programmed retraction feedrate FR.
Programming technological functions (cycles)
10.1 Drilling
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0 377
To Next Page
Loading...
Need help?
General
