Hidden parameters
The following parameters are hidden. They are preassigned fixed values or values that can
be adjusted using setting data.
Parameter Description Value Can be set in SD
PL (only for G code) Machining plane Defined in MD
52005
SC (only for G
code)
Safety clearance 1 mm x
Reference point Position of the reference point: Center
Machining
position
Mill slot at the programmed position (X0, Y0, Z0). Single posi‐
tion
α0 Angle of rotation 0°
Machine manufacturer
Please refer to the machine manufacturer's specifications.
10.2.8 Circumferential groove (SLOT2)
Function
You can mill one or several circumferential slots of equal size on a full or pitch circle with the
"circumferential slot" cycle.
Tool size
Please note that there is a minimum size for the milling cutter used to machine the
circumferential slot:
● Roughing:
1⁄2 groove width W – finishing allowance UXY ≤ milling cutter diameter
● Finishing:
1⁄2 groove width W ≤ milling cutter diameter
● Edge finishing:
Finishing allowance UXY ≤ milling cutter diameter
Annular groove
To create an annular groove, you must enter the following values for the "Number N" and
"Aperture angle α1" parameters:
N = 1
α1 = 360°
Programming technological functions (cycles)
10.2 Milling
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0 455
To Next Page
Loading...
Need help?
General
