6. When required, change the specified name of the originally selec‐
ted program in the "File name" field.
7. Press the "OK" softkey.
The setup data will be set up in the same directory in which the
selected program is stored.
The file is automatically saved as INI file.
Note
Identical names
If a main program as well as an INI file with the same name are in a directory, when selecting
the main program, initially, the INI file is automatically started. In this way, unwanted tool data
can be changed.
Machine manufacturer
Please observe the information provided by the machine manufacturer.
14.17.2 Reading-in set-up data
When reading-in, select which of the backed-up data you require:
● Tool data
● Magazine assignment
● Zero points
● Basic zero point
Tool data
Depending on which data you have selected, the system behaves as follows:
● Complete tool list
First, all tool management data are deleted and then the saved data are imported.
● All tool data used in the program
If at least one of the tools to be read in already exists in the tool management system, you
can choose between the following options.
Select the "Replace all" softkey to import all tool data. Any existing tools
will now be overwritten without a warning prompt.
- OR -
Press the "Do not overwrite" softkey if existing tools must not be over‐
written.
Already existing tools are skipped, without you receiving any queries.
Managing programs
14.17 Setup data
Milling
796 Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
To Next Page
Loading...
Need help?
General
