Hidden parameters
The following parameters are hidden. They are pre-assigned fixed values or values that can
be adjusted using setting data.
Parameter Description Value Can be set in SD
PL (only for G code) Machining plane Defined in MD
52005
SC (only for G
code)
Safety clearance 1 mm x
Drilling depth Drilling depth in relation to the tip Tip
FD1 Percentage for the feedrate for the first infeed 90 % x
DF Percentage for each additional infeed 90 % x
V1 Minimum infeed 1.2 mm x
V2 Retraction distance after each machining step 1.4 mm x
Clearance distance The clearance distance is calculated by the cycle Automatic
DBT Dwell time at drilling depth 0.6 s x
DT Dwell time at final drilling depth 0.6 s x
DTS (only for G
code)
Dwell time for swarf removal (for swarf removal only) 0.6 s x
Machine manufacturer
Please refer to the machine manufacturer's specifications.
10.1.6 Deep-hole drilling 2 (CYCLE830)
Function
The cycle "Deep-hole drilling 2" covers the complete functionality of "Deep-hole drilling 1".
in addition, the cycle provides the following functions:
● Predrilling with reduced feedrate
● Taking into account a pilot hole
● Soft first cut when entering the material
● Drilling to the final depth in one cut
● Through drilling with reduced feedrate
● Control for switching-in and switching-out the coolant
Programming technological functions (cycles)
10.1 Drilling
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0 383
To Next Page
Loading...
Need help?
General
