8.9 Calling technology functions
8.9.1 Hiding cycle parameters
The documentation describes all the possible input parameters for each cycle. Depending on
the settings of the machine manufacturer, certain parameters can be hidden in the screens,
i.e. not displayed. These are then generated with the appropriate default values when the
cycles are called.
References
For additional information, please refer to the following documentation:
SINUMERIK Operate Commissioning Manual
Cycle support
Example
1. Use the softkeys to select whether you want support for programming
contours, drilling or milling cycles.
2. Select the desired cycle via the softkey.
3. Enter the parameters and press the "Accept" key.
The cycle is transferred to the editor as G code.
8.9.2 Setting data for cycles
Cycle functions can be influenced and configured using machine and setting data.
References
For additional information, please refer to the following documentation:
SINUMERIK Operate Commissioning Manual
8.9.3 Checking cycle parameters
The entered parameters are already checked during the program creation in order to avoid
faulty entries.
Generating a G code program
8.9 Calling technology functions
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0 311
To Next Page
Loading...
Need help?
General
