18.3 Machine control panel menu
You select keys from the machine control panel which are reproduced by the software by touch
operation of the relevant softkeys.
See Section "Controls on the machine control panel" for a description of the individual keys.
Note
PLC interface signals that are triggered via the softkeys of the machine control panel menus
are edge triggered.
Showing and hiding
The user menu key "U" displays the CPF softkey bar (vertical softkey bar) and the user softkey
bar (horizontal softkey bar).
Press the menu forward key to extend the horizontal user softkey bar. There
are 8 additional softkeys available.
You use the "Back" softkey to hide the menu bar again
HT 8 (840D sl only)
18.3 Machine control panel menu
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0 865
To Next Page
Loading...
Need help?
General
