Service Planner (828D only)
22
22.1 Performing and monitoring maintenance tasks
With the "Service Planner", maintenance tasks have been set up that have to be performed
at certain intervals (e.g. top up oil, change coolant).
A list is displayed of all the maintenance tasks that have been set up together with the time
remaining until the end of the specified maintenance interval.
The current status can be seen in the status display.
Messages and alarms indicate when a task has to be performed.
Acknowledging a maintenance task
Acknowledge the message when a maintenance task has been completed.
Service Planner
Display Meaning
Pos Position of the maintenance task in the PLC interface.
Maintenance task Name of the maintenance task.
Interval [h] Maximum time until next servicing in hours.
Remaining time [h] Time until the interval expires in hours.
Status Display of the current status of a maintenance task.
The maintenance task has been started.
The maintenance task is completed.
The maintenance task is deactivated.
Procedure
1. Select the "Diagnostics" operating area.
2. Press the menu forward key and then the "Service planner" softkey.
The window with the list of all the maintenance tasks that have been set
up appears.
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0 895
To Next Page
Loading...
Need help?
General
