Siemens SINUMERIK 840DE SL User Manual

$
<
=
Figure 10-1 Y axis is centered above the cylinder
=
<
$
˂<
Figure 10-2 Y axis is not centered above the cylinder
XYA plane
You program in XYA if the Y axis should also move during machining. A value can be specified
for each position.
In addition to the possibilities of XA, the following is also possible, for example.
Programming technological functions (cycles)
10.1 Drilling
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0 409

Siemens SINUMERIK 840DE SL Specifications

General

Brand	Siemens
Model	SINUMERIK 840DE SL
Category	Control Systems
Language	English