9. Press the "Insert variable" softkey if you wish to select a variable from a
list of all existing variables and insert this.
The "Select Variable" window opens.
10. Press the "Filter/search" softkey to restrict the display of variables (e.g.
to mode group variables) using the "Filter" selection box and/or select the
desired variable using the "Search" input box.
11. Press the "Delete all" softkey if you would like to delete all the entries for
the operands.
12. Press the "OK" softkey to confirm the changes or the deletion.
- OR -
Press the "Cancel" softkey to cancel the changes.
Editing the variable list
You can edit the variable list using the "Insert line" and "Delete line" softkeys.
If you press the softkey, a new line inserted before the line marked by the
cursor.
You can only use the "Insert line" softkey if there is at least one empty
line at the end of the variable list.
The softkey is deactivated if there is no empty line.
If you press the "Delete line" softkey, the line marked by the cursor is
deleted.
An empty line will be added at the bottom of the variable list.
Changing operands
Depending on the type of operand, you can increment or decrement the address by 1 place
at a time using the "Operand +" and "Operand -" softkeys.
Note
Axis names as index
For axis names, the "Operand +" and "Operand -" softkeys do not act as index, e.g. for
$AA_IM[X1].
Alarm, error, and system messages
15.6 PLC and NC variables
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0 819
To Next Page
Loading...
Need help?
General
