Parameterizing machine data
3.1 Handling machine data via the HMI
HMI Advanced (IM4)
Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
95
• General display machine data
• Channel-specific display machine data
• Machine data for SIMODRIVE drives (powerline)
• Machine data for SINAMICS drives, for Control Units, I/O modules and infeed
Example
Creating user view TEST01:
1. Select "New View". An empty window is opened in order to insert the appropriate
machine data and comment lines.
2. In order to insert a comment, select "Insert Text...", and enter a text, for example, "text
line 1". Acknowledge using the <INPUT> key in order to accept the text.
3. In order to insert a machine data, select "Insert Data...". Select the machine data area,
e.g. "Axis-specific machine data". The corresponding range of numbers 30 000 - 38 000
is displayed in the list:
4. Mark machine data 32 000. In order to transfer the machine data into the user view, press
the softkey "Insert before/after line".
5. For additional machine data, proceed in the same way or user "Search": Within a range of
numbers, you can also mark and insert a machine data directly using "Search".
6. In order to complete the selection, press the softkey "<<" to return to the window "Edit
View".
Result:
Figure 3-2 Example: User view
To Next Page
Loading...
Need help?
General
