Tool management
6.4 Job processing of tools
HMI Advanced (IM4)
Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
245
● 00 00 FF 00: Green
● 00 FF 80 00: Blue green
Examples for setting colors, see [BatchTools], "General settings which apply to all filters" in
paramtm.txt.
Bitmaps for the status display of the individual job elements
The user can replace the names of the bitmaps or the bitmaps themselves with custom
bitmaps. The custom bitmaps are stored in the "user" directory.
Examples for setting bitmaps, see [BatchTools], "General settings which apply to all filters" in
paramtm.txt.
Example:
BatchFilterElBUnTUnBitmap = pbfbutu.bmp
BatchFilterElBUnTSeBitmap = pbfbuts.bmp
BatchFilterElBSeTUnBitmap = pbfbstu.bmp
BatchFilterElBSeTSeBitmap = pbfbsts.bmp
BatchRunElWaitingBitmap = pbbwait.bmp
BatchRunElInWorkBitmap = pbbwork.bmp
BatchRunElOKBitmap = pbbok.bmp
BatchRunElErrorBitmap = pbberr.bmp
Width of a typical character
For each language you can specify a character whose width is used as the basis to calculate
column widths from a specified number of characters. A wide character should be entered
here, in Europe typically an "X" or "A".
Example:
Paramtm.ini, [BatchTools]:
CharToGetColWidthPerCharacter=CharToGetColWidth ;language-specific
language\patm_gr.ini, [BatchTools]:
CharToGetColWidth="A"
Column width for tool identifier
You can set the column width for the tool identifier as as a rule the full number of 32
characters is not used.
Example:
Paramtm.ini, [BatchTools]:
ResultDisplayedNumberOfToolnameCharacters=18
To Next Page
Loading...
Need help?
General
