393
In a 1M/E box switcher configuration, the channel is
fixed and hence a channel cannot be assigned.
1
Open the Home > Setup > Switcher > Multi Viewer >
Channel Assign menu (19103.22).
2
Select the target multi viewer channel to set.
3
Assign a hardware block (physical block) of the
switcher configured as a multi viewer to a channel.
To release the assignment
Set the [No Assign] button to the on state.
Setting a DME External
Input (Ext In)
You can set the signal (AUX bus output) that is input on
Ext In on a DME.
1
Open the Home > Setup > Switcher > DME Interface
menu (19103.31).
2
Select the target DME channel to set.
3
Press the [Edit] button for [Aux Bus].
The [Select Source] window appears.
4
Set the button for the target AUX bus to the on state.
5
Press [OK].
Note
To Next Page
Loading...
Need help?
General
