Chapter
278
16
Snapshots
Overview
A snapshot is a function that saves the configured status
for applying an effect to an image in a register which can
be used to reproduce the same state. You can save a
snapshot in a register and then recall it as required.
Snapshot registers
You can create a snapshot for the following regions.
Switcher bank regions:
M/E-1 to M/E-5, P/P, M/E-1 Sub to M/E-5 Sub, P/P
Su
b
User regions:
User 1 to User 8
DME regions:
DME 1 to DME 4 (including Global)
External device regions:
Router
There are 999 snapshot registers for each region.
Snapshots for function targets
In addition to snapshots for region targets, there are also
snap
shots for specific function targets.
Key snapshot: Snapshot of settings on each key.
For details, see “Key Snapshots” (page 145).
Wipe snapshot: Snapshot of wipe settings on each
swit
cher bank.
For details, see “Wipe Snapshots” (page 160).
DME wipe snapshot: Snapshot of DME wipe settings of
ea
ch switcher bank.
For details, see “DME Wipe Snapshots” (page 172).
Attributes
You can add specific attributes for running a snapshot
when it is recalled.
You set attributes for a snapshot register.
Attribute types
You can add the following attributes.
Cross-point hold: When the snapshot is recalled, the
c
ross-point selection information remains
unchanged.
Auto transition: An auto transition starts simultaneously
aft
er a snapshot is recalled.
Effect dissolve: The image changes smoothly from the
st
ate before the snapshot is recalled to the snapshot
state.
Auto play: Plays video content immediately after the
snap
shot is recalled.
Cross-point hold (DME): Sets cross-point hold for a
DME
region.
• Cross-point hold operation mode is applied to key bus
cr
oss-point hold attributes.
For details, see “Setting the Cross-Point Hold
Operation Mode” (page 396).
• If both effect dissolve and auto transition are
confi
gured, the auto transition takes precedence.
Notes
To Next Page
Loading...
Need help?
General
