Tektronix TAS 475 Service Manual

Warranted Characteristics
Table 1-11: Warranted Characteristics - Time Base System (Cont.)
Name
TAS 475 Time Base Accuracy,
Magnify
On
TAS 485 Time Base Accuracy,
Magnify
On
Horizontal Position Control Range
Variable Control Range
1-12
Description
The limits are as follows:
Conditions
Time Measurement Accuracy
-10° C to + 55 ° C
Excluding
5 ns/div and ±4%.
2 ns/div
5 ns/div and 2 ns/div
±3%.
-10° Cto + 15° Cand
+ 35 ° C to + 55 ° C
5 ns/div and 2 ns/div ±5%.
Sweep accuracy applies over the center eight divisions. Excludes
the greater of either the first Y4 division or 25 ns from the sweep start
of the magnified sweep and anything beyond the 100th magnified
division.
The limits are as follows:
Conditions
Time Measurement Accuracy
-10° Cto+55° C
Excluding
2 ns/div and ±4%.
1 ns/div
2 ns/div and 1 ns/div
±3%.
-10° C to + 15° C and
+ 35 ° C to + 55 ° C
2 ns/div and 1 ns/div ±7%.
Sweep accuracy applies over the center eight divisions. Excludes
the greater of either the first Y4 division or 25 ns from the sweep start
of the magnified sweep and anything beyond the 1
DOth magnified
division.
The position
control is able to move the start of the sweep to the
right of the center
vertical graticule and able to move a time mark
corresponding to the tenth division
on an unmagnified sweep to the
left of the graticule center.
Continuously variable between calibrated seconds/division settings.
Extends both the Main and
Delayed sweep seconds/division set-
tings by a factor of 2.5 times.
Specifications
•
•
•
Scan by Zenith

Tektronix TAS 475 Specifications

General

Brand	Tektronix
Model	TAS 475
Category	Test Equipment
Language	English