Tektronix TAS 475 Service Manual

•
•
•
Typical Characteristics
This subsection contains tables that lists the various typical characteristics
that describe the TAS 475 and TAS 485 Analog Oscilloscopes.
Typical
characteristics are described in terms of typical or average
performance.
Typical characteristics are not warranted.
This subsection
lists only typical characteristics. A list of warranted charac-
teristics starts on page 1-9.
Table 1-18: Typical Characteristics - Vertical Deflection System
Name Description
Upper-Frequency Limit, 20 MHz Band- 20 MHz.
width Limited
Trace
Shift Leakage The typical amount of trace shift while changing the input coupling
between GND and 1 MO DC is as follows:
Condition Typical Trace Shift
<0.5 mY.
<2 mY.
Variable Volts/Div Offset 0.5 division trace shift while changing the variable volts/div setting.
Chop Mode
Clock Rate
>500 kHz, < 1 MHz.
Chop mode
is allowed from 0.5 s to 10 Ils sec/div settings.
TAS 475 Noise (measured tangentially) • ::; 0.06 div at :2: 10 mV/div (600 1lV).
• ::;0.10 div at 5 mV/div (500 1lV).
• ::; 0.14 div at 2 mV /div (280 1lV).
TAS 485 Noise (measured tangentially) • ::; 0.06 div at :2: 10 mV/div (600 1lV).
• ::;0.10 div at 5 mV/div (500 1lV).
• ::;0.15 div at 2 mV/div (300 1lV).
TAS 475 and TAS 485 Service Manual
1-17
Scan by Zenith

Tektronix TAS 475 Specifications

General

Brand	Tektronix
Model	TAS 475
Category	Test Equipment
Language	English