Toyota 3L User Manual

STARTING SYSTEM - Pre-Heatina Svstem (Super Glow Type [2L-TI )
ST-5
No.1 Glow Plug Relay (LJ)
s
LOCATION :
In the engine compartment on the left side.
INSPECT RELAY CONTINUITY
(a)
Using an ohmmeter, check that there is continuity
between terminals
E and g.
(b) Check that there
is no continuity between terminals
B and G.
If continuity
is not as specified, replace the relay.
INSPECT RELAY OPERATION
(a)
Apply battery voltage across terminals E and g.
(b)
Using an ohmmeter, check that there
is continuity
between terminals
B and G.
If operation is not as specified, replace the relay.
No.2 Glow Plug Relay (LJ)
LOCATION : In the engine compartment on the left side.
INSPECT RELAY CONTINUITY
(a)
Using an ohmmeter, check that there is continuity
between terminals e and g.
(b) Check that there
is no continuity between terminals
B and G.
If continuity is not as specified, replace the relay.

Toyota 3L Specifications

General

Displacement	2.8 L (2, 779 cc)
Compression Ratio	22.2:1
Fuel Type	Diesel
Valvetrain	SOHC, 8 valves
Fuel System	Indirect injection
Power Output	91 hp (68 kW) at 4, 000 rpm
Aspiration	Naturally aspirated
Cooling System	Water-cooled
Bore x Stroke	96 mm x 96 mm (3.78 in x 3.78 in)
Cylinder Arrangement	Inline-4