7 TRANSMISSION
NOTE:
•
Detent springs MUST NOT be interchanged. The
NEUTRAL spring has a white mark and is fi
tt
ed
rearmost in the crankcase.
• The neutral detent arm is angled in toward the
crankcase whereas the gearchange detent arm
is angled out towards the detent wheel.
10.
Check that the detent arms correctly align when
neutral and all gears are selected. Also check that
there is no binding of the arms during operation.
1w.
ME
Detent Position 1st. Gear
Detent Position Neutral
11.
Apply 'Loctite 270' to the oil pressure relief valve
threads and tighten the valve to 15 Nm.
12.
Refit the oil pump and tighten the pump fixings to 12
Nm.
13.
Position the selector forks to the selector drum, in
the order noted during removal.
14.
Support the selectors and feed the selector shaft
through the crankcase and selectors. Fit the shaft
keeper plate and tighten the retaining bolt to 6 Nm.
-
^
e
/-^=
1
gada
1. Selector Shaft Keeper Plate
7.16
To Next Page
Loading...
Need help?
General
