BRAKING SYSTEM 13
Installation
1.
Fit the reservoir hose to the master cylinder.
2.
Secure the master cylinder and cover to the
frame. Tighten the securing screws to
30 Nm.
NOTE:
•
The brake light switch and spacer washer fits
between the master cylinder and frame.
3.
Connect the push rod to the brake pedal using a
new clevis pin and split pin.
4.
Using new washers, fit the brake hose to the
master cylinder. Ensuring correct orientation of
the brake hose, tighten the banjo bolt to
25 Nm.
5.
Fit the brake light switch.
WARNING: Use only D.O.T. 4
specification brake fluid as listed in the
general information section of this manual. The
use of brake fluids other than those D.O.T. 4 fluids
listed in the general information section may
reduce the efficiency of the braking system
leading to an accident.
Observe the brake fluid handling warnings given
earlier in this section of the manual.
6.
Fill and bleed the rear brake system as described
earlier.
7. Reconnect the battery positive, (red) lead first.
8. Fit the body rear panels and seat.
13.21
To Next Page
Loading...
Need help?
General
