T
MPH
FUEL SYSTEM/ENGINE MANAGEMENT 9
Assembly
1.
Fit the camshaft position sensor and tighten the
fixing to
10 Nm.
2.
Fit the ignition coils and tighten the coil fixings to 10
Nm.
3.
Reconnect the ignition coils.
4.
Refit the fuel tank and airbox as described
elsewhere in this section.
5.
Refit the side panels and seat.
6.
Reconnect the battery positive (red) lead first.
ROAD SPEED SENSOR (early models only)
NOTE:
•
This item has been deleted from later models.
Removal
1.
Release the sensor multiplug.
2.
Release the screw securing the sensor to the
bracket and detach the sensor.
Assembly
1.
Assemble the sensor to the bracket and tighten
the fixing to
6 Nm.
2.
Rotate the rear wheel until one of the sprocket
bolt heads aligns with the sensor.
3.
Slacken the sensor bracket bolts and adjust the
sensor bracket to give a
1
mm gap between the
sensor and the bolt head.
THROTTLE CABLE
Removal
1.
Remove the seat and disconnect the battery
negative (black) lead first.
2.
Remove the fuel tank and airbox as described in
this section.
3.
Slacken the adjuster locknut at the throttle body
end of the cable such that it will allow the outer
cable to be detached from the cable bracket.
gajm
1.
Outer Cable
2.
Adjuster Locknut
3.
Cable Bracket
4.
Detach the inner cable from the throttle cam.
5.
At the twist grip end, slide off the rubber boot and
release the screws which secure the two halves
of the twist grip guide to each other.
\
'
-'\\\\\ \
gakp
1. Twist Grip
1.
Sprocket
2. Twist Grip Guide
2.
1 mm gap
3. Screws
6.
Slide off the boot and separate the two halves of
the guide. Release the throttle inner cable from
the twist grip.
9.89
To Next Page
Loading...
Need help?
General
