T
MH
ELECTRICAL SYSTEM 16
Headlight Bulb Replacement
1. Bulb Retainer
2.
Position Light
Each halogen headlight bulb can be replaced as follows:
WARNING: The bulb becomes hot during
use. Always allow sufficient time for the
bulb to cool before handling.
Avoid touching the glass part of the bulb. If the
glass is touched or gets dirty, clean with alcohol
before re—use.
1.
Disconnect the battery, negative (black) lead first.
2.
Release the headlight bezel clamp screw.
3. Support the headlight unit and remove the bezel.
Ease the headlight from the headlight bowl.
4.
Disconnect the multi—pin electrical connector from
the headlight bulb and remove the rubber cover.
5.
Unhook the wire retaining clip from behind the
bulb.
6.
Remove the bulb from the headlight unit.
Installation
Installation is the reverse of the removal procedure.
Position Lamp Bulb Replacement
Position lamps are fitted to both headlight units. To
replace a position light bulb, remove the headlight unit
from the headlight bowl to gain access for position light
bulb replacement.
16.17
To Next Page
Loading...
Need help?
General
