COOLING SYSTEM 10
Installation
1.
Replace the water pump '0' ring seal.
2.
Align the drive slot in the water pump with the
drive slot on the oil pump (inside the crankcase)
NOTE:
•
The water pump will not engage fully into the
crankcase unless the drive slots are engaged.
1. Water pump slot
3.
Fit the pump and tighten the fixings to
10 Nm.
4.
Refit the hoses to the water pump and tighten the
clips.
5.
Refit the coolant drain plug and tighten to
13 Nm.
1
1. Coolant Drain Plug
6.
Refill the cooling system as described earlier in
this section.
7.
Reconnect the battery positive (red) lead first.
8.
Start the motorcycle and allow the engine to idle
for a short period of time to allow any air to be
expelled from the system.
9. Stop the engine and top up the coolant level as
necessary.
10. Fit the coolant pressure cap.
11.
Check the expansion tank level and top up if
necessary.
12.
Refit the fuel tank cover.
13.
Refit the seat.
14.
Refit the left hand lower fairing and belly panel
(where removed earlier).
10.7
To Next Page
Loading...
Need help?
General
