6.
Switch the headlights off when the beam se
tt
ings
are satisfacto
ry
.
16 ELECTRICAL SYSTEM
HEADLIGHTS — DAYTONA
2
\
/'
1.
Vertical Adjustment Screw (LH)
2.
Horizontal Adjustment Screw (LH)
L
LJ/
^^ l
Headlight Adjustment
1.
Each headlight can be adjusted by means of
vertical and horizontal adjustment screws located
on the rear of the headlight unit.
2.
Switch the headlight dipped beam on.
3.
Turn the vertical adjustment screw on each
headlight clockwise to lower the beam or
anti—clockwise to raise the beam.
4.
On the RH headlight turn the horizontal
adjustment screw clockwise to move the beam to
the right or anti—clockwise to move the beam to
the left.
5.
On the LH headlight turn the horizontal
adjustment screw anti—clockwise to move the
beam to the right or clockwise to move the beam
to the left.
1.
Vertical Adjustment Screw (RH)
2.
Horizontal Adjustment Screw (RH)
A
WARNING: Adjust road speed to suit the
visibility and weather conditions in which
the motorcycle is being operated.
Ensure that the beam is adjusted to illuminate the
road surface sufficiently far ahead without
dazzling oncoming traffic. An incorrectly adjusted
headlight may impair visibility causing an
accident.
A
WARNING: Never attempt to adjust the
headlamp beam when the motorcycle is
in motion.
Any attempt to adjust the headlamp beam when
the motorcycle is in motion may result in loss of
control and an accident.
16.14
To Next Page
Loading...
Need help?
General
