Triumph Daytona 955i User Manual

9 FUEL SYSTEM/ENGINE MANAGEMENT
T
MpH
Assembly
1.
Fit new seals to the cylinder head.
gaky
1.
Cylinder Head
2.
Seals
NOTE:
•
A smear of grease may be used to retain the
seals in the cylinder head during assembly.
2.
Locate the downpipes and align the downpipe
flanges to the fixings points.
3.
Tighten the downpipe flange fixings in stages;
first tighten all downpipe fixings to 8 Nm,
then tighten all downpipe fixings to 12 Nm.
4.
Refit the radiator and refill the cooling system as
described in the cooling section.
5.
Position and engage the silencer to the downpipe.
6.
Align the silencer mounting bracket to the rear
footrest support.
7.
Ensuring that the flanged sleeves, bushes and
washers are positioned as shown in the diagram,
fit the silencer mounting bolt and tighten to 18
Nm.
5 4
dd
^^ P ^^
^o
3
Z
4
1.
Silencer Mounting Bolt
2.
Flanged Sleeves
3.
Rubber Bushes
4.
Flat Washers
5.
Securing Nut
8.
Refit the springs securing the silencer to the
downpipe.
9.
Refit the fairing belly panel (if removed earlier).
10.
Reconnect the battery, positive (red) lead first.
11.
Refit the seat.
12.
Start the engine and check for exhaust gas leaks
etc. Rectify as necessary.
9.100

Triumph Daytona 955i Specifications

General

Brand	Triumph
Model	Daytona 955i
Category	Motorcycle
Language	English