ThUMII
FUEL SYSTEM/ENGINE MANAGEMENT 9
2.
Locate the housing to the airbox ensuring the
gasket is correctly positioned. Tighten the
screws.
3.
Refit the fuel tank as described elsewhere in this
section.
4.
Reconnect the battery, positive (red) lead first.
5.
Refit the seat.
BAROMETRIC PRESSURE SENSOR
Removal
1.
Remove the seat and disconnect the battery
negative (black) lead first.
2.
Remove the fuel tank and airbox as described
elsewhere in this section.
NOTE:
•
The barometric pressure sensor is a push fit in
the airbox and is retained by a barbed seal.
3.
Remove the sensor by gently pulling in an
outward direction.
1.
Intake Air Temperature Sensor
2.
Barometric Pressure Sensor
Assembly
1.
Align the sensor to the airbox and push fully
home.
2.
Refit the airbox and fuel tank as described
elsewhere in this section
3.
Reconnect the battery, positive (red) lead first.
4.
Refit the seat.
9.85
To Next Page
Loading...
Need help?
General
