T11 U Mi 1' H
BRAKING SYSTEM 13
FLUID LEVEL INSPECTION
In accordance with the scheduled maintenance chart,
inspect the brake fluid level in the front and rear
master cylinder reservoirs.
1.
Ensure that the brake fluid level in the front and
rear brake fluid reservoirs is between the upper
and lower level lines (reservoir held horizontal).
1.
Front Reservoir Lower Level
2.
Front Reservoir Upper Level
--
s
J ^
r2i
1
i
gadu
'
1
1.
Rear Reservoir Lower Level
2.
Rear Reservoir Upper Level
CHANGING BRAKE FLUID
Brake fluid should be changed at the interval specified
in the scheduled maintenance chart.
BRAKE PADS
Front and Rear pad wear is automatically
compensated for and has no effect on brake lever or
pedal action.
BRAKE WEAR INSPECTION
In accordance with the scheduled maintenance chart,
inspect the brake pads for wear. The minimum
thickness of lining material for any front or rear brake
pad is 1.5mm. If any pad has worn to the bottom of the
groove in the pad centre, replace all the brake pads on
that wheel.
T
gadq
1.
Lining material thickness
2.
Centre groove
A
WARNING: Do not replace individual
brake pads, replace both pads in the
brake caliper. On the front where two calipers are
mounted on the same wheel, all the pads in both
calipers must be replaced together. Replacing
individual pads will reduce braking efficiency and
may cause an accident.
13.7
To Next Page
Loading...
Need help?
General
