INTRODUCTION
ASBESTOS
This warning may apply to
any
of
the
following
components
or any
assembly containing one or
more of these components:—
WARNING
I
Gaskets
CONTAINS
ASBESTOS
I
Insulators
Breathing asbestos
dust is dangerous
to
health
Follow safety
instructions
SAFETY INSTRUCTIONS
•
Operate if possible out of doors or in a well
ventilated place.
•
Preferably use hand tools or low speed tools
equipped with an appropriate dust extraction
facility.
•
Dampen dust and place in a properly closed
receptacle. Dispose of the closed receptacle
safely.
•
Never use an airline to blow dust from
components
TAMPERING WITH NOISE CONTROL SYSTEM
PROHIBITED
Owners are warned that the law may prohibit:
(a)
The removal or rendering inoperative by any
person other than for purposes of maintenance,
repair or replacement, of any device or element
of design incorporated into any new vehicle for
the purpose of noise control prior to its sale or
delivery to the ultimate purchaser or while it is in
use; and
(b)
the use of the vehicle after such device or
element of design has been removed or rendered
inoperative by any person.
REFERENCES
References
References to the left-hand or right-hand side given in
this manual are made when viewing the motorcycle
from the rear.
Operations covered in this manual do not always
include reference to testing the motorcycle after repair.
It is essential that work is inspected and tested after
completion and if necessary a road test of the
motorcycle is carried out particularly where safety
related items are concerned.
Dimensions
The dimensions quoted are to design engineering
specification with service limits where applicable.
During the period of running-in from new, certain
adjustments may vary from the specification figures
given in this manual. These will be reset by the dealer
at the 500 mile/800 km service, and thereafter should
be maintained at the figures specified in this manual.
REPAIRS AND REPLACEMENTS
Before removal and disassembly, thoroughly clean the
motorcycle. Any dirt entering the engine or other parts
will work as an abrasive and shorten the life of the
motorcycle. Particular attention should be paid when
installing a new part, that any dust or metal filings are
cleared from the immediate area.
Force
Common sense should dictate how much force is
necessary in assembly and disassembly. If a part
seems especially difficult to remove or install, stop and
examine what may be causing the problem. Never
lever a component as this will cause damage both to
the component itself and to the surface being levered
against.
Whenever tapping to aid removal of an item is
necessary, tap lightly using a hide or plastic faced
mallet.
To Next Page
Need help?
General
