Xerox D136 User Manual

Cause and Remedy (Action)Symptoms
The document glass or the document cover is dirty.CauseYesThe image is not the
desired size
If No, go to next symptom.
Clean the document glass or the document cover.Action
If problem is not solved, go to next Cause/Action.
The document is made of highly transparent
material like a transparency.
Cause
Place a white sheet of paper on the document and
scan.
Action
If problem is not solved, go to next Cause/Action.
The document is misaligned.Cause
Load the document correctly.Action
If problem is not solved, go to next Cause/Action.
The document guides are in an incorrect position.Cause
Load the document correctly, and align the
document guides with the edges of the document.
Action
If problem is not solved, go to next Cause/Action.
The document is a non-standard size.Cause
Enter the document size and then scan.Action
If problem is not solved, go to next Cause/Action.
The document is folded or bent.Cause
Straighten and properly reset the document.Action
Resolution is too low.CauseYesThe image is coarse
Set a higher resolution.Action
Copy troubleshooting
To use the following troubleshooting procedures:
1. Begin by reading the first symptom at the left side of the page.
2. If the description of the symptom is false (NO), move downward to the next symptom.
Continue down through the symptoms until you find the symptom that describes
the problem.
3. Refer to the Causes and Actions to the right of the correct symptom. Perform the
suggested actions until the problem is solved.
15-37Xerox
®
D95/D110/D125/D136 Copier/Printer
User Guide
Problem solving

Xerox D136 Specifications

General

Brand	Xerox
Model	D136
Category	Copier
Language	English