The Standard Finisher Plus consists of these two modules:
1. Finisher Module
2. Finishing Transport
Output prints are fed from the machine (and any attached optional finishing device) to
the Finisher Module. The Finishing Transport serves as an interface to transfer paper
from the Finisher Module and the attached third-party output device. The Finishing
Transport moves the paper from the Finisher Module to one of the three Finishing
Transport exits. The height of the paper entry on the third-party, DFA device must align
with the Finishing Transport exit 1 or exit 2.
The Finishing Transport is built to support a number of finishing operations ranging
from light-production print engines to futuristic devices that utilize other communication
and physical interfaces.
Finisher Module
Finisher Module main components
The Finisher Module includes the following components:
FunctionComponentNo.
Output prints are fed from the machine through the
required Interface Module or Interface Cooling Module
(depending on product and machine configuration) to
the Finisher Module which then feeds the prints to the
Finishing Transport for delivery to a third-party output
device.
The Finisher Module is shown here with the optional C/Z
Folder.
Finisher Module1
User Guide24-2
Standard Finisher Plus
To Next Page
Loading...
Need help?
General