FUEL
Fuel system
4-17
60C5D11
Assembling the carburetor
1. Install the main nozzle
1
, main jet
2
,
pilot jet
3
, plug
4
, and valve seat
5
to
the carburetor body as shown.
2. Install the needle valve
6
, float
7
, float
pin
8
, and screw
9
as shown, and then
check the float for smooth operation.
NOTE:
• Place the needle valve in the valve seat
when installing the float to the carburetor
body.
• Fit the float pin into the slit on the carbure-
tor body and lock it with the screw.
3. Install the pilot screw
0
, turn it in until it
is lightly seated, then out the specified
number of turns.
Adjusting the throttle link rod
1. Set the throttle control lever to the fully
closed position.
2. Check that the mark
a
on the throttle
cam aligns with the center of the link
lever
b
as shown.
3. Contact the throttle control lever
1
with
the fully closed stopper
2
.
4. Check that the throttle is fully closed, and
that the fully closed mark
a
on the throt-
tle cam
3
is aligned with the center of
the link lever
b
.
S60C4220
S60C4230
Pilot screw setting:
1 1/2–2 1/2 turns out
S60C4240
To Next Page
Loading...
Need help?
General
