MP-1xx SIP User’s Manual 5. Configuring the MP-1xx
Version 4.4 123 March 2005
Note 1: Saving a configuration file to flash memory may disrupt traffic on the MP-1xx.
To avoid this, disable all traffic on the device before saving to flash memory.
Note 2: A device reset is required to activate a loaded CPT file.
7. To save the loaded auxiliary files so they are available after a power fail refer to Section 5.12
on page 139.
8. To reset the MP-1xx refer to Section
5.12 on page 139.
5.9.5 Changing the MP-1xx Username and Password
To prevent unauthorized access to the MP-1xx, it is recommended that you change the username
and password (both are case-sensitive) that are used to access the Web Interface.
To change the username and password, take these 5 steps:
1. Open the ‘Change Password’ screen (Advanced Configuration menu > Change
Password); the ‘Change Password’ screen is displayed.
Figure
5-35: Change Password Screen
2. In the ‘User Name’ and ‘Password’ fields, enter the new username and the new password
respectively. Note that the username and password can be a maximum of 7 case-sensitive
characters.
3. In the ‘Confirm Password’ field, reenter the new password.
4. Click the Change Password button; the new username and password are applied and the
‘Enter Network Password’ screen appears, shown in Figure 5-1 on page 41.
5. Enter the updated username and password in the ‘Enter Network Password’ screen.
To Next Page
Loading...
Need help?
General
