MP-1xx SIP
MP-1xx SIP User’s Manual 66 Document #: LTRT-65404
5.8.2.3 Keypad Features
The Keypad Features screen (applicable only to FXS gateways) enables you to activate /
deactivate the following features directly from the connected telephone’s keypad:
• Call Forward (refer to Section
5.8.8.4 on page 96).
• Caller ID Restriction (refer to Section
5.8.8.3 on page 95).
• Hotline (refer to Section
5.8.8.2 on page 94).
To configure the keypad features, take these 4 steps:
1. Open the ‘Keypad Features’ screen (Protocol Management menu > Advanced
Parameters submenu > Keypad Features option); the ‘Keypad Features’ screen is
displayed.
Figure
5-9: Keypad Features Screen
2. Configure the Keypad Features according to Table
5-7.
3. Click the Submit button to save your changes.
4. To save the changes so they are available after a power fail refer to Section
5.12 on page
139.
Note: The method used by the gateway to collect dialed numbers is identical to the
method used during a regular call (i.e., max digits, interdigit timeout, digit
map, etc.).
To Next Page
Loading...
Need help?
General
