MP-1xx SIP
MP-1xx SIP User’s Manual 144 Document #: LTRT-65404
“Number of Call Progress Tones” defining the number of Call Progress Tones that are
defined in the file.
• [CALL PROGRESS TONE #X] – containing the Xth tone definition (starting from 1 and not
exceeding the number of Call Progress Tones defined in the first section) using the following
keys:
Tone Type – Call Progress Tone type
Figure
7-1: Call Progress Tone Types
1 - Dial Tone
2 - Ringback Tone
3 - Busy Tone
7 - Reorder Tone
8 - Confirmation Tone
9 - Call Waiting Tone
15 - Stutter Dial Tone
16 - Off Hook Warning Tone
17 - Call Waiting Ringback Tone
23 - Hold Tone
Low Freq [Hz] – Frequency in hertz of the lower tone component in case of dual
frequency tone, or the frequency of the tone in case of single tone.
High Freq [Hz] – Frequency in hertz of the higher tone component in case of dual
frequency tone, or zero (0) in case of single tone.
Low Freq Level [-dBm] – Generation level 0 dBm to –31 dBm in [dBm].
High Freq Level – Generation level. 0 to –31 dBm. The value should be set to ‘32’ in the
case of a single tone.
First Signal On Time [10 msec] – “Signal On” period (in 10 msec units) for the first
cadence on-off cycle.
First Signal Off Time [10 msec] – “Signal Off” period (in 10 msec units) for the first
cadence on-off cycle.
Second Signal On Time [10 msec] – “Signal On” period (in 10 msec units) for the
second cadence on-off cycle.
Second Signal Off Time [10 msec] – “Signal Off” period (in 10 msec units) for the
second cadence on-off cycle.
Default Duration [msec] - The default duration (in 1 msec units) of the generated tone.
Note 1: When the same frequency is used for a continuous tone and a cadence
tone, the ‘Signal On Time’ parameter of the continues tone must have a
value that is greater than the ‘Signal On Time’ parameter of the cadence
tone. Otherwise the continues tone is detected instead of the cadence tone.
Note 2: The tones frequency should differ by at least 40 Hz from one tone to other
defined tones.
For example: to configure the dial tone to 440 Hz only, define the following text:
To Next Page
Loading...
Need help?
General
