MP-1xx SIP User’s Manual 5. Configuring the MP-1xx
Version 4.4 55 March 2005
5.8.1.4 DTMF & Dialing Parameters
Use this screen to configure parameters that are associated with DTMF and dialing.
To configure the dialing parameters, take these 4 steps:
1. Open the ‘DTMF & Dialing’ screen (Protocol Management menu > Protocol Definition
submenu > DTMF & Dialing option); the ‘DTMF & Dialing’ parameters screen is displayed.
Figure
5-6: DTMF & Dialing Parameters Screen
2. Configure the DTMF & Dialing parameters according to Table
5-4.
3. Click the Submit button to save your changes.
4. To save the changes so they are available after a power fail refer to Section
5.12 on page
139.
Table
5-4: DTMF & Dialing Parameters (continues on pages 55 to 57)
Parameter Description
Max Digits in Phone Num
[MaxDigits]
Note: Digit Mapping Rules
can be used instead.
Maximum number of digits that can be dialed.
You can enter a value from 1 to 49.
The default value is 5.
Note: Dialing ends when the maximum number of digits is dialed, the Interdigit Timeout
expires, the '#' key is dialed, or a digit map pattern is matched.
Inter Digits Timeout [sec]
[TimeBetweenDigits]
Time in seconds that the gateway waits between digits dialed by the user. When the
Interdigit Timeout expires, the gateway attempts to dial the digits already received.
You can enter a value of 1 to 10 seconds. The default value is 4 seconds.
To Next Page
Loading...
Need help?
General
