MP-1xx SIP User’s Manual 3. Installing the MP-1xx
Version 4.4 33 March 2005
To cable the MP-10x/FXS Lifeline phone, take these 3 steps:
1. Connect the Lifeline Splitter to port #4 (on the MP-104/FXS or MP-108/FXS) or to port #2 (on
the MP-102/FXS).
2. Connect the Lifeline phone to Port A on the Lifeline Splitter.
3. Connect an analog PSTN line to Port B on the Lifeline Splitter.
Note: The use of the Lifeline on network failure can be disabled using the
‘LifeLineType’ ini file parameter (described in Table 5-29 on page 108).
Figure 3-12: MP-104/FXS Lifeline Setup
Table
3-4: MP-104/FXS Lifeline Setup Component Descriptions
Item # Component Description
1
B: To PSTN wall port.
2
Phone to Port 1.
3
Lifeline to Port 4.
4
PSTN to Splitter (B).
5
Phone to Port 1.
6
Lifeline phone to Splitter (A).
7
Lifeline phone.
1
2
3
4
5
6
7
To Next Page
Loading...
Need help?
General
